FAQs - Toggle-Lok Positive Early Ejector Return
Does the Toggle-Lok use springs?No. The Toggle-Lok is an externally mounted device used to positively return the ejector assembly before the mold closes. It does not utilize springs.Instead, it uses a positive cam linkage and actuator lever rather than springs, hydraulics or pneumatics.
Does D-M-E manufacture specials of the Toggle-Lok?
Unfortunately, D-M-E does not manufacture special sizes of the Toggle-Lok. However, the D-M-E Mold Components Catalog has several pages devoted to component sizing so that customers may manufacture their own special sizes to suit specific needs.
Are the Bermer Early Return and the Toggle-Lok the same?
Yes. This device was obtained from Bermer Tool and Die.
For additional information about D-M-E Toggle-Lok, refer to the installation instructions packaged with each unit. For other concerns, contact D-M-E Applications Engineering at appl_eng@dme.net or 800-626-6653 (U.S.) or 248-398-6000 (worldwide).
